BSP SL20da (1.5 ton) & SL30da (2.5 ton)
Available for Hire & Sale throughout the UK, Ireland and Europe
To make an enquiry:
Tel: +44 (0)1473 748652
Email: info@w-h.co.uk
Or click here to complete our webform.
Hydraulic Piling Hammers
Click here to download technical specification sheet.
Introduction
Designed for driving sheet piles and small bearing piles of concrete, steel or timber. The SL range is available with legs and inserts for use freely suspended or with backguides for operating from a piling mast.
The SL20da and SL30da hammers are sized for driving single sheet piles and can pass between upstanding piles.
Using a unique BSP double-acting cylinder the ram is accelerated on its downward path to achieve higher impact energy. The energy is developed from a short stroke leading to a high blow rate and greater pile productivity compared to an equivalent single-acting hammer.
The low hook weight, and relatively small hydraulic power required to operate, make these hammers an economical option for the construction of pile walls, coffer dams and temporary earthworks.
The hammers are not limited to sheet piles but can be fitted out too drive bearing piles of pre-stressed concrete, steel or timber with ultimate load bearing up to 1800kN depending on site conditions.
BSP can provide a suitable power pack built around a perkins 1004-40T engine, weighing 2300kg gross, which develops up to 71Kw @ 1800rpm. Alternatively if the carrier is a hydraulic base with suitable open-circuit power-take-off the hammer can be easily plumbed in to this.
Control
The hammers are adjusted using a single variable flow control. The control box can be remote from the power pack or mounted on board.
Features/benefits
- Drives all single sheet piles
- High impact to weight ratio
- Can be suspended from small capacity cranes
- Simple operation
Please click here to download technical specification sheet.